How to winterize a pool in short: deep-clean the basin, balance the water and add a winterizing chemical, lower the water level below the return jets, fully drain the pump, filter and pipes, and close the pool with a light-proof winter cover. Done before the first hard frost, this prevents burst pipes, ice damage to the liner and equipment, and a green pool in spring. This guide explains the right order of work, how vinyl liner pools, one-piece fibreglass pools and indoor pools differ, and what pool winterization costs in Austria.
What does it mean to winterize a pool?
Winterizing – also called closing the pool for winter – covers every job that helps an outdoor pool survive the cold season undamaged. In most cases the bulk of the water stays in the basin. It stabilises the walls, counteracts the pressure of soil and groundwater on one-piece shells and keeps the liner from drying out. What gets drained and frost-proofed are all the components in which standing water would cause damage when it freezes.
A typical pool closing includes:
- Deep cleaning: removing deposits, leaves and dirt from the waterline, walls, floor, skimmer, return jets and pool surround.
- Water care: adjusting the pH, shocking the water one last time and adding a winterizing product that slows algae and limescale while the pool is dormant.
- Protecting the equipment: draining, blowing out and plugging the pump, filter, heat pump or solar collector, dosing or salt system and the pipework.
- Covering: fitting a tight, well-tensioned winter cover or safety cover that blocks light and keeps leaves out.
Why is it important to close your pool properly?
1. Freezing water bursts pipes and housings
Water expands by roughly nine percent as it freezes. In a pump, filter tank or plastic pipe, one night of hard frost is enough to crack a housing or loosen a fitting. The damage often only shows in spring, when the system is switched back on and water suddenly pools in the equipment pit. A properly drained system is therefore the single most important step.
2. Ice pressure strains the liner, skimmer and coping
When a sheet of ice forms on the surface, it pushes sideways against the pool wall and against built-in parts such as skimmers, lights and jets. That is why the water level is lowered below these fittings, and many owners also float ice compensators – also known as air pillows or winter floats – that absorb the pressure.
3. Algae, scale and biofilm while the pool sleeps
Even at low temperatures, pool water is not completely inactive. Organic residue from leaves, sunscreen and skin oils feeds algae and bacteria. Without cleaning and winter chemicals, stubborn deposits build up over the months and take a lot of effort to shift in spring. The photo further down shows what that can look like.
4. Protecting your investment and an easier spring opening
A pool liner can last many years with good care. Permanent stains, a scaled waterline or a damaged skimmer shorten its life considerably. Careful winterization in autumn saves expensive repairs and means far less chemistry to get the water clear again in spring.
When should you winterize your pool?
As a rule of thumb, close the pool once the water temperature stays below roughly 12 to 15 °C. In warmer water, the active ingredients in winterizing products break down faster and algae still have too much energy. In Vienna, Graz and Linz this is usually the case from mid-October; at higher altitudes around Salzburg, often a little earlier. What matters is that everything is finished before the first nights of sustained frost. If you are not done by mid-November, act now – especially on the equipment.
How to winterize a pool: step by step
The basic rule of all cleaning applies to pools too: work from top to bottom and from clean to dirty. Start with the surroundings, the pool edge and the waterline, then the walls and floor, and finish with the filter, which collects the loosened dirt. Only then is the water treated, lowered and the equipment shut down.
- Clear the surroundings: sweep leaves from the deck and coping and remove loungers, toys and ladders, so no fresh dirt falls into the water while you work.
- Clean the waterline: remove the greasy, chalky ring with a waterline cleaner suitable for vinyl liners and a soft sponge. Never use scouring agents or household cleaners – they attack the liner and cause foam.
- Brush the walls: work from top to bottom with a soft pool brush, paying particular attention to corners, steps and recesses.
- Vacuum the floor: pick up the loosened dirt with a manual vacuum or a robotic cleaner. Skim off coarse leaves with a net beforehand.
- Skimmer, jets and lights: empty the skimmer basket and the pump strainer basket, clean the return jets and light rings.
- Backwash the filter: backwash and rinse a sand filter thoroughly; remove and clean a cartridge filter. The filter comes last on purpose, because it takes up the dirt from the previous steps.
- Balance the water: bring the pH to about 7.0 to 7.4, then shock the pool and let the system run for a few more hours.
- Add the winterizing chemical: once the chlorine level has dropped again, add the winterizer according to the manufacturer’s instructions and circulate it with the pump.
- Lower the water level: usually to about 10 to 15 cm below the return jets or the skimmer. The pool manufacturer’s specifications take priority.
- Drain the equipment: fully drain the pump, filter tank, heat pump and pipes, blow out the lines with compressed air or a wet vac and seal the openings with winter plugs.
- Add ice compensators: spread floating air pillows or special compensators so the ice has somewhere to release pressure.
- Cover the pool: tension the winter cover tightly, lock the safety cover or close the slatted cover. The cover must block light, otherwise algae will grow despite the winterizer.
Water balance and winter chemicals
Winterizing products – sold as winter concentrate, winterizer or algae-and-scale preventer – contain active ingredients that work against algae and limescale. They only work if the water is balanced first. A pH that is too high causes scale to precipitate; one that is too low can attack metal parts. Test with a reliable kit and aim for these guideline values:
| Parameter | Guideline before closing | Note |
|---|---|---|
| pH | approx. 7.0 to 7.4 | adjust first, then chlorinate |
| Total alkalinity | approx. 80 to 120 mg/l | buffers the pH over winter |
| Free chlorine | shock, then let it drop | do not add winterizer to heavily chlorinated water |
| Water temperature | consistently below approx. 12 to 15 °C | close later if the water is warmer |
Store chemicals dry, frost-free, out of children’s reach and separately from each other. Chlorine products and pH reducers must never be mixed in the same container, as dangerous gases can form. Expired leftovers belong at your municipality’s hazardous waste collection point, not down the drain.
Vinyl liner, fibreglass shell or indoor pool – what is different?
Vinyl liner pools (in-ground steel-wall or concrete pools with a liner) are never drained completely. Without water, the liner can shrink, wrinkle or come away from the wall; in the worst case it tears when refilled. The built-in fittings are also critical, which is why lowering the water below skimmer and jets matters so much here.
One-piece fibreglass or polyester pools are light and have little dead weight of their own. With a high water table, an empty shell can literally float and lift out of the ground. They also stay filled and are only lowered as far as the manufacturer allows. Pools with an overflow channel often come with separate instructions for the balance tank.
Above-ground pools and inflatable or frame pools are usually taken down completely, cleaned, dried and stored frost-free, because their walls cannot withstand ice pressure.
Indoor pools do not need winterizing. Autumn is still a good time to deep-clean the basin, joints and pool surround, to replace filter media and to check the dehumidification. The room should stay heated and dehumidified, otherwise condensation and mould can form on ceilings and windows.
Who does what: cleaning versus technical work
The deep clean before closing is manual work that requires knowledge of liners and care products. Shutting down a heat pump, a salt chlorinator or an automatic dosing system, on the other hand, is a job for a pool builder or building services technician, because probes, electrodes and heat exchangers each have their own requirements. Many owners combine the two: the cleaning company gets the basin spotless, the technician shuts down the system. When you refill in spring, it is worth knowing the water hardness in your area – for Vienna, the city publishes the figures on its Vienna drinking water page (in German).

Fee’s tip for pool owners: take a photo of every valve position, every fitting and the setting of the multiport valve while you winterize. In spring you will know exactly how everything goes back together – and a cover that goes onto a clean pool in autumn reveals a clean pool in April.
You make the mess – we make it go away
Sie machen Dreck – wir machen's weg
How much does it cost to winterize a pool? Price guidelines for 2026
The price depends mainly on pool size, how dirty it is, access and whether the cover is fitted as well. One-off jobs such as the deep clean before closing are charged by time from €50 per hour net plus travel; smaller, easily planned pools can also be done for a flat fee. Ongoing weekly pool care during the season costs €41.20 per hour net. All prices are exclusive of VAT.
| Service | Vienna | Graz | Linz | Salzburg |
|---|---|---|---|---|
| Deep clean before closing, liner pool up to approx. 8 × 4 m (flat fee) | from approx. €290 | from approx. €310 | from approx. €310 | from approx. €330 |
| Deep clean for larger pools or heavy soiling | by time, from €50 per hour plus travel | |||
| Cleaning the pool surround, deck and equipment pit | by time, from €50 per hour plus travel | |||
| Cleaning and fitting a winter cover (standard cover) | from approx. €90 | from approx. €100 | from approx. €100 | from approx. €110 |
| Ongoing weekly pool care in season | €41.20 per hour | |||
All prices are net guideline values; you receive a binding fixed price after the site visit. Winterizing chemicals, ice compensators and the technical shutdown of a heat pump or salt system by a pool builder are not included. You can read what our service covers on the pool cleaning page; for pools in the city and the surrounding area, see pool cleaning in Vienna.
How working with us works
For the assessment, a few photos of the basin, the waterline and the equipment pit are often enough. We schedule the appointment so that cleaning is done before the first hard frost and use liner-safe products throughout. Our customers rate us 4,8 stars from 200 reviews.
How to winterize a pool: common mistakes
- Draining the pool completely: liners shrink and fibreglass shells can be lifted by groundwater. A partial drain is enough.
- Leaving the water above the skimmer: the ice then presses directly on the skimmer and jets, causing cracks and leaks.
- Switching off the lines instead of draining them: even a little water left in a pipe bend can freeze and burst the pipe.
- Covering a dirty pool: leaves and deposits under the cover decompose over winter and the water turns despite the winterizer.
- Adding winterizer to freshly shocked water: high chlorine levels break down the active ingredients and the product is wasted.
- Using a translucent cover: a solar cover is not a winter cover. Light encourages algae growth.
- Leaving chemicals in the garden shed: frost and damp degrade the products, and different chemicals must never be stored together.
- Forgetting the cover all winter: remove snow loads and standing rainwater from the cover regularly, or eyelets and straps may tear.
How to winterize a pool: checklist
- Water temperature consistently below approx. 12 to 15 °C
- Leaves and objects around the pool removed
- Waterline cleaned with a liner-safe cleaner
- Walls brushed, floor vacuumed
- Skimmer basket, strainer, jets and lights cleaned
- Sand filter backwashed or cartridge cleaned
- pH adjusted, pool shocked
- Winterizer added according to the label
- Water lowered below skimmer and return jets
- Pump, filter, heat pump and lines drained and plugged
- Ice compensators in place
- Light-proof winter cover fitted tightly
- Chemicals stored dry, frost-free and separately
- Valve positions photographed, cover checks scheduled
How to winterize a pool: FAQ
How far should I lower the water for winter?
Typically about 10 to 15 cm below the return jets or the skimmer opening. Always follow the pool manufacturer’s specifications.
Can I drain my vinyl liner pool completely for winter?
It is better not to. Without water the liner can shrink, wrinkle or detach. Lowering the level partially protects the liner and fittings more reliably.
Why should a fibreglass pool not be left empty over winter?
Light one-piece shells can float and lift when the groundwater is high. The water in the pool acts as a counterweight.
When do I add the winterizing chemical?
After cleaning, once the pH is balanced and the chlorine level from the shock has dropped again. Let the pump circulate it for a few hours before lowering the water.
What happens if water is left in the pipes?
Freezing water expands and can burst pipes, pump housings and filter tanks. That is why lines are drained, blown out and sealed with winter plugs.
What kind of cover is best for winter?
A light-proof, tear-resistant winter cover with a tensioning system, or a walk-on safety cover. A thin solar cover is not enough because it lets light through.
Does an indoor pool need to be winterized?
No. An indoor pool keeps running. Autumn is still a good time for a deep clean, filter maintenance and a check of the dehumidification system.
How much does pre-winter pool cleaning cost in Vienna?
For a liner pool up to roughly eight by four metres, the guideline starts at around €290 net. Larger or very dirty pools are charged by time from €50 per hour net plus travel; you get a fixed price after the site visit.
Is mid-November too late to close a pool?
Not necessarily. What matters is that the pump, filter and pipes are drained before the first sustained frost. In cold water, cleaning and winterizer actually work better than in a warm early autumn.
Get your pool cleaned before winter
A pool that is closed clean is ready for swimming much sooner in spring. If the deep clean is too much work or the pool is already very dirty, we take care of that part: waterline, walls, floor, skimmer and surround, thoroughly and with liner-safe products. Briefly describe your pool and feel free to add photos – you will receive a guideline price and, after the site visit, a fixed price.

Fee is looking forward to your pool: Bling Bling Premium Reinigung gets pools in Vienna and the surrounding area ready for winter.
You make the mess – we make it go away
Sie machen Dreck – wir machen's weg
